Any loctite between the sleeve and crank?Īnd lastly, when installing the sleeve with the seal around it, what keeps the seal from sliding off the end of the sleeve as the sleeve is pressed around the crank and the seal is pressed inside the seal housing? Do you press the sleeve on a little, tap the seal in, press the sleeve, tap the seal? Or do I install the sleeve into the housing first and then press the entire assembly back on?Įdit** Thinking about it more seems like I should seat the seal with the sleeve into the housing on the bench and then install all of it together. You will need to get it from Cummins, or maybe you can borrow one from a shop that has it. What's the best way to install it without the tool? I plan to cut out some hardwood and back it with 1/4" plate to push it on with the flywheel bolts and then seat it the rest of the way with the flywheel itself. The seal with the sleeve is to be installed with the tool. Second, the sleeve and seal gets installed as an assembly I believe. The crankshaft seal is the primary barrier that keeps oil from leaking from the rear or front end of the crankshaft. I had the rear seal housing off when I went through the motor on the engine stand and centered it with a micrometer the best I could (didn't have dowels to do it the right way).įirst question is, should I remove the housing with the seal in place, clean up the mating surface and then reinstall the housing with the "old new" seal to center the housing? Is this an acceptable way to center the seal housing around the crank or do I need to source dowels before the job? 3164780 Crankshaft Rear Main Seal Wear Sleeve Remover Installer Tool Kit Fits for Cummins ISX QSX ISX15 ISX12 Diesel Engines Set Country/Region of Car. Never done a sleeve before on any motor and was looking for a little advice.Ĭurrent seal is weeping and I can't stand the leak, so it's coming out. 3164780 Crankshaft Rear Main Seal Wear Sleeve Remover Installer Tool Kit Replacement for ISX QSX ISX15 ISX12 Features: -Crafted from quality carbon steel. Hey guys getting ready to yank the trans again and install my new rear main and sleeve from cummins.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |